DREO DR-HTF007 Manual Del Usuario página 16

Idiomas disponibles
  • ES

Idiomas disponibles

Rear Grille
WARNING
Turn off the appliance and unplug before any cleaning and
maintenance.
1
Remove the screw on the top of the rear
grille with a Philips screwdriver.
2
3
Clean the dust on blades using a
vacuum cleaner or air duster.
Rinse the rear grille under running
water or with a clean, damp cloth.
Dry up, then install the grille and the screw back by following the
4
reverse order of disassembly.
27
Lift up the grille and pull it out.
TROUBLESHOOTING
My fan won't turn on!
Make sure that the cord is connected to a powered outlet and the
mains voltage corresponds with the voltage indicated on the fan.
My fan is shaky and wobbling!
1.
Place the fan on a flat, level surface.
2.
Incorrect installation might also cause shakiness. Please refer to the
assembly instructions in
page 18-19
be run through all rear keepers.
My fan is making vibration and noise!
1.
Place the fan on a flat, level surface.
2.
Be sure not to insert anything into the air inlet and outlet.
If your problem is not listed or still persists, please contact our Customer
Support (see page 71)
Correct Disposal of this product
This marking indicates that this product should not be disposed of
with other household waste throughout the EU. To prevent possible
harm to the environment or human health from uncontrolled waste
disposal, recycle it responsibly to promote the sustainable reuse of
material resources To return your used device, please use the return
and collection system or contact the retailer where the product was
purchased. They can take this product for environmentally safe
recycling.
6
.Note that the power cord must
.
28
loading

Productos relacionados para DREO DR-HTF007