Idiomas disponibles
Idiomas disponibles
UK
If the circuit breaker stops the appliance or the appliance becomes jammed:
Press the OFF/REVERSE button immediately.
1.
Press the CIRCUIT BREAKER button.
2.
Press and HOLD the OFF/REVERSE button to clear the blockage.
3.
Turn off the appliance and disconnect from the power supply.
4.
Remove and clear the mincing barrel and all components.
5.
Cleaning, Care & Maintenance
Note: Always switch off and disconnect the appliance from the power supply before
cleaning.
•
Do not use any abrasive cleaning agents on the appliance. Use warm soapy water.
•
Do not immerse the motor housing in water. Clean the exterior with a damp cloth.
•
Always dry thoroughly after cleaning.
•
A BUFFALO agent or qualified technician should carry out repairs if required.
For ease of cleaning, disassemble the appliance:
•
Unscrew the barrel cap.
Note: If the cap has been put on too tight, knock the corners of the cap with a rubber
mallet or similar instrument to loosen it.
•
Remove the mincing barrel, plate, blade and feed screw as one unit. Gently tip the barrel to remove
the pieces one by one.
•
Twist off the hopper tray.
•
Remove meat from all components and wash in warm, soapy water.
•
Dry thoroughly.
•
Lubricate the parts with a little cooking oil before replacing for best performance.
Troubleshooting
If your BUFFALO appliance develops a fault, please check the following table before making a call to the
Helpline.
Fault
The appliance is not working
3
Probable Cause
The appliance is not switched on
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
Action
Check the appliance is plugged in correctly
and switched on
Call BUFFALO agent or qualified technician
Replace the plug fuse
Check power supply
Call BUFFALO agent or qualified technician
