Idiomas disponibles
Idiomas disponibles
SETUP
1. Place station on work surface at a minimum of two
inches away from wall.
2. Insert metal end of conical support into slot at the
top of the safety rest base. (See Figure 1)
3. Dampen cleaning sponge and place into safety rest.
(See Figure 2)
4. Place iron into the conical support. (See Figure 2)
5. Attach heat resistant cable to the front of the digital
station. Align the cord with the port and rotate to
secure connection. (See Figure 3)
6. Plug the 120 volt power cord into back of digital
station. Connect to a grounded 120 volt outlet.
OPERATION
1. Switch station on and press menu button. (See Figure 4)
2. Use arrows and menu button to set the following:
• Standby Time: Amount of inactive time before the
machine goes to sleep.
NOTE: Once set, press the menu button to
advance.
• Offset Temperature: Used to fine-tune temperature
measured at the tip compared to station reading.
NOTE: Offset temperature is only needed where
accuracy of temperature to the degree is
required.
• Display in Fahrenheit or Celsius
• Set password if desired: Choose any number 1-999
and hold the menu button for five seconds to lock. To
unlock, press the menu button, scroll to the previously
chosen number and press the menu button again.
NOTE: When locked, settings cannot be
changed.
CHANGING TIPS
WARNING! Ensure iron is cool before
changing tips.
1. Unscrew and remove the cover retaining the solder
tip. Tip will fall out of the iron. (See Figure 5)
2. Replace with desired compatible tip and secure
with previously removed cover.
PAGE 2 OF 6
INSTRUCTIONS
Figure 1
Figure 3
Figure 4
Power Switch
Figure 5
1-800-295-5510
uline.com
Figure 2
Arrow Buttons
Menu Button
Cover
0623 IH-10799
