Stander Pole Instrucciones De Uso página 12

Instruction manual
Floor-ceiling rod "Pole
Item number: POLE1100
4.4 Attach the base plate (part 5) to the standpipe with handle (part 4) by aligning the groove in part 4 with
the inside tenon in part 5 so that the groove is on both sides of the tenon to prevent rotation of the base
plate (part 4) and standpipe with handle (part 5) (see Figure 3).
4.5 Insert the threaded part from the adjustment tube (part 3) into the stand tube with handle (part 4) and
place the floor-ceiling rod "Pole" at the desired location, with the base plate part 5 on the floor and the
upper frame (part 1) on the ceiling.
Make sure that the plastic spacer washer (part 11) is mounted between the adjusting nut (part 8) and
the washer (part 9) -as shown in figure 1 before inserting the adjusting tube with threaded part (part 3)
into the standpipe with handle (part 4).
4.6 To securely fasten the floor-ceiling rod "Pole" between the floor and the ceiling, turn the adjusting nut
(part 8) clockwise using the supplied installation wrench (part 12). Tighten the lower adjusting nut until
the floor-ceiling rod "Pole" is fixed between floor and ceiling.
Make sure that the floor/ceiling rod is aligned at a right angle (perpendicular) to the floor.
4.7 Additional securing:
If additional securing of the floor-ceiling rod "Pole" is to be done or is necessary, this can be done by
screwing each 2 times through the upper frame (part 1) to the ceiling as well as through the base plate
(part 5) to the floor of the installation environment as shown in Figure 4.
The use of suitable mounting material (not included in the scope of delivery). is absolutely necessary.
4.8 Operation:
Pull the pin on the handle of the standpipe (part 4) and turn the curved handle to the desired position.
Release the pin and continue to turn the handle until the spring-loaded pin locks into place, securing the
handle in the desired position.
A slight play of the swivel handle is normal and is not a safety issue. This play allows the locking pin to
easily engage in the 8 available user-friendly positions.
Groov
e
Internal pin
FIGURE 3
Fixing the upper
frame part 1 to the
ceiling
FIGURE 4
Seite 12 von 44
Fastening the base
plate part 5 to the
floor