Casselin CLVA50 Manual página 22

All manuals and user guides at all-guides.com
EN
The dishwasher should preferably be emptied on the floor, since emptying takes place by gravity. If the
machine is equipped with a drain pump, the position of the connection can be on the wall, but in any case it
cannot be placed at a height higher than that indicated in Fig. E.
Electrical connection
A GOOD EARTHING INSTALLATION, COMPLIANT WITH THE STANDARDS OF
PREVENTION IN FORCE, OFFERS A GUARANTEE OF SAFETY, AND FOR
THE USER, AND FOR THE EQUIPMENT.
This fundamental point must absolutely be checked and if there is the slightest doubt, ask the personnel
professionally competent to make the connection to the network, to carefully examine the installation in
question.
WE ARE NOT RESPONSIBLE FOR ANY DAMAGES
MAY RESULT FROM A LACK OF EARTHING.
It is absolutely forbidden to use adapters, multiple sockets and extension cords. Make sure that the power
supply corresponds to the indications on the characteristics label located on the machine. The equipment
must be included in an equipotential system verified according to the European standards in force in this
regard.
Make the connection using the screw (C-9) bearing the symbol placed on the back of the machine and
using a terminal suitable for the 10mm2 section provided for by standard CEI64.8.
The connection to the power supply line must be made by means of a multi-pole differential
magnetothermal switch whose contact opening distance is equal to or greater than 3mm. To choose the
type and dimensions of the power cable, take into account: the existing distance between the machine and
the connection point, the installed power indicated on the characteristics label located on the machine (C-3)
and line voltage. However, the cross-section of the cables must not be less than 2.5 mm².
Use type H07RN-F by connecting it to the terminal block reserved for this purpose and locking it with the
cable clamp.
Avoid pulling on the power cable.
Check the safety thermostats of the FB3 heating tank (if provided) by pushing the manual reset button.
The machine is set as standard with a water heater temperature of 85 ° C. The variations of this value are made by turning the thermostat screw.
The installation must comply with standard CEI64.8 (IEC 364).
Safety measures and user training
The specialized personnel who carry out the installation and the electrical connection are required to
properly instruct the user on the operation of the device and the possible safety measures to be observed.
The installer must also provide a practical demonstration of the user manual to the user, and must leave
the written instructions delivered with the device.
This appliance is delivered to you with dimensions and connections of energy sources - technical sheet -
electrical diagram.
USE
Open the water tap and turn on the main switch installed upstream of the machine.
Close the door and press the line button (A1): the indicator light (A5) comes on.
The machine automatically fills with water and when the level is reached in the tank, the resistance of the
tank is activated. When the water has reached the temperature, the heating resistance will turn off and the
resistance of the tank will come on. The activation of a resistance is signaled by the indicator light (A7).
A few minutes later, the machine is ready for use.
When the indicator light (A7) goes out, you can press the button to start the wash cycle START (A2). When
the wash cycle begins, the indicator light (A-6) lights up.