Idiomas disponibles
Idiomas disponibles
• The agent will be sprayed along with water.
• Do not leave any unused agent in the tank, but empty it before
3.3.4
Unblocking the nozzle
Sometimes it may happen that the water jet from the nozzle is
uneven or unstable, i.e. it interrupts. If the flow does not improve
after a while, the nozzle is most likely clogged. In this case, please:
• Release the trigger of the gun.
• Turn off the device
• Trigger the gun to release any residual water and pressure from
• Remove the nozzle from the spray lance and inspect it for a
• Use the supplied needle with a finger eyelet to thread the
• Reattach the nozzle to the spray lance and see if cleaning helped.
3.4.
Cleaning and maintenance
a)
Before any cleaning, adjustment, or replacement of accessories, and if the
device is not in use, pull out and completely cool down the device, wait for the
rotating parts to stop, and get rid of residual water with pressure from the
system.
b)
Use only non-corrosive cleaning agents for cleaning the surfaces.
c)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
d)
Do not spray the unit with a stream of water or immerse it in water.
e)
Make sure that no water enters through the ventilation openings in the casing.
f)
Clean the ventilation openings with a brush and compressed air.
HT-HPW-180A
putting the unit into storage.
the gun.
blocked opening.
blocked nozzle.
