Idiomas disponibles
Idiomas disponibles
HOW TO INSTALL THIS UNIT WITH PLUG CONNECTED WIRE:
1.
Drill 2 holes of 6mm diameter and depth of 35mm on the wall then insert the plastic wall anchors
into the holes according to picture 2 and fix the plastic hanger with 1 screw enclosed.
2.
Align installation clip on the back cover to the hanger and push down.
3.
Fix the bracket to the wall, then screwing the screw in top of the bracket back cover, fix the bracket
tightly.
4.
Connect with general power and move power switch to "ON" position.
HOW TO INSTALL THIS UNIT WITHOUT PLUG-CONNECTED WIRE:
1.
Loosen the screw on the bottom of the dryer bracket to disassemble the front cover, open the
wire entry hole.
2.
Pull the reserved wire through the hole showed in picture 2 (there are three holes available for
the direct wiring).
3.
Fix the reserved wire on terminal, please notice its direction of N, L wire replace terminal to its
original position.
4.
Fix the bracket to the wall then fix the front cover to the bracket screwing the screw on the bottom
to make the bracket and front cover tightly. Then align installation clip on the back cover to the
hanger and pull down, fix bracket.
5.
Connect with general power and move power switch to "ON" position.
HOW TO USE:
Switch on general power and pick up the dryer body, the dryer will work when the spring button is
held on, move the push button up and down for higher or lower heating. "2" for hot heating, "1" for
warm heating, "C" for ambient temperature.
Notes:
1.
Ensure the voltage of hair dryer is same with the power supply.
2.
Please follow the below safety frameworks when you operate the hair dryer. Don't operate the hair
dryer when your hands are wet. Don't pull out the combined cord.
Please pull out the power plug from electrical outlet when you cleaning the hair dryer. Please pay
attention the hair dryer to avoid absorbing in the inlet of hair dryer. Please use the cleaning solution
of water with soap to clean the housing of hair dryer, don't use spray liquid or abrasive.
Picture 2
Picture 3
