WARNING: Turn power off at circuit breaker or fuse.
Place tape over circuit breaker switch and verify power is
off at the fixture.
This fixture comes with an "Easy Install" mounting plate. It is pre-
assembled on the fixture for shipping.
1. Unscrew the large mounting bolt connecting the light fixture to
the mounting plate and remove the mounting plate (see Figure 1).
The mounting bolt is designed to stay in the light fixture.
2. Install the mounting bracket with the stamped word "FRONT"
facing away from the junction box (see Figure 2). Use the mount-
ing bracket screws that best fit the junction box.
3. Route the junction box wires through the hole in the mounting
plate (see Figure 3).
4. Place the mounting plate against the junction box (see Figure 3).
• Wall Mounted – The "UP" arrow must point upward
• Eave Mounted – The "UP" arrow must point toward the building
5. Insert the small mounting bolt through the mounting plate hole
located below the threaded hole. Thread the bolt into the center
hole of the mounting bracket (see Figure 3). Tighten bolt securely.
Insert the junction box wires into the side of the terminal block and
around the ground screw (see Figure 4). Tighten terminal block screws
and ground screw to secure wires.
• White to "N (White)"
• Black to "L (Black)"
• Bare or green ground wire to GND (ground) screw.
FINAL ASSEMBLY
1. Double check that all wiring connections are securely connected.
2. Align the bottom edge of the light fixture with the bottom edge
of the mounting plate. Tilt the light fixture toward the mounting
plate, making sure the light fixture is centered on the mounting
plate.
IMPORTANT: The two pins on the rear of the light fixture must
insert into the terminal block for the light to work.
3. Tighten the mounting bolt securely being careful not to overtighten
(see Figure 5).
210226-02
INSTALLATION
WIRING
To see operational and troubleshooting information and videos,
go to www.hzsupport.com
Figure 1
T
O N
F R
T
O N
F R
Figure 2
Figure 3
UP/Haut/Arriba
GND
Terre
Tierra
Figure 4
T
N
O
R
F
N (White/
Blanc/Blanco)
L (Black/
Noir/Negro)
3