Idiomas disponibles
Idiomas disponibles
11. Automated Learning Process./Activating Code.
CAUTION: The wall or handheld remote control can be programmed to multiple receivers or fans. If this is not desired, turn
wall switch off to any other programmable receiver or fan.
Restore electrical power and then, if using wall control, set slider switch on wall control to the ON position. Within 60
seconds of turning on the wall control, press and hold the fan OFF button on the wall control for 5 seconds or until
light blinks twice.
Turn power off again for at least 5 seconds and then turn power back on. Within 60 seconds of restoring the power,
press and hold the fan OFF button on the front of the handheld remote control for 5 seconds or until light blinks
twice.
Test the light and fan functions to confirm the learning process is complete--see Section 13 below.
12. Remote/Wall Control Operation.
ON/OFF slider switch - turns wall control ON or OFF
HIGH button
- turns fan to HIGH speed
MED button
- turns fan to MEDIUM speed
LOW button
- turns fan to LOW speed
OFF button
- turns fan OFF
L button
- turns light kit ON/OFF when pressed once;
13. Testing Your Fan.
It is recommended that you test fan before finalizing installation.
Restore power from circuit box and light switch (if applicable).
Test wall control (optional installation) by locating ON/OFF slider
switch on wall control, then set to the ON position. Test light and
dimmer function and then test fan speeds. Next, locate handheld
remote control. Test the light ON/OFF function by pressing the L
button; test the dimmer function by pressing the L button and holding
it down for up to 5 seconds. Test fan speeds with the different fan
speed buttons. If the wall and/or handheld remote control operates all
of the functions of the fan, battery (batteries) has (have) been installed
correctly. If the wall and/or handheld remote control do (does) not
operate all of the fan/light functions, refer to "Troubleshooting" section
to solve any issues before contacting Customer Service.
Turn fan completely off before moving the reverse switch (located on
top of motor housing). Set reverse switch to recirculate air depending
on the season:
- LEFT position in summer (diagram 1)
- RIGHT position in winter (diagram 2)
A ceiling fan will allow you to raise your thermostat setting in summer
and lower your thermostat setting in winter without feeling a
difference in your comfort.
Important: Reverse switch must be set either completely LEFT or
completely RIGHT for fan to function. If the reverse switch is set in the
middle position (diagram 3), fan will not operate.
NOTE: If the wall control/handheld remote control interferes with other
appliances, turn power off first and then go back to the instructions in
Section 11.
(switch not functional on handheld remote)
dims light kit when pressed and help down.
page 11
wall control
remote control
diagram 1
diagram 2
handheld
reverse
switch
diagram 3
