Turntable Installation; Countertop Installation - URSUS TROTTER UT-25KROMM Manual De Usuario

F
G
A) Control panel
B) Turntable shaft
C) Turntable ring assembly
D) Glass tray
E) Observation window
F) Door assembly
G) Safety interlock system

Turntable Installation

Hub (underside)
Glass tray
Turntable shaft
a. Never place the glass tray upside down. The glass tray
should never be restricted.
b. Both glass tray and turntable ring assembly must always be
used during cooking.
c. All food and containers of food are always placed on the
glass tray for cooking.
d. If glass tray or turntable ring assembly cracks or breaks,
contact your nearest authorized service
center.

Countertop Installation

Remove all packing material and accessories. Examine the
oven for any damage such as dents or broken door. Do not
install if oven is damaged.
Cabinet: Remove any protective film found on the microwave
oven cabinet surface.
Do not remove the light brown Mica cover th at is att ach ed
to th e ov en c avity to protect the magnetron.
Installation
1.Select a level surface that provide enough open space for
the intake and/or outlet vents.
A
E
D C B
Turntable ring assembly
(1) The minimum installation height is 85cm.
(2) The rear surface of appliance shall be placed against a
wall.
Leave a minimum clearance of 30cm above the oven, a
minimum clearance of 20cm is required between the oven
and any adjacent walls.
(3) Do not remove the legs from the bottom of the oven. (4)
Blocking the intake and/ or outlet openings can damage the
oven.
(5) Place the oven as far away from radios and TV as possible.
Operation of microwave oven may cause interference to your
radio or TV reception.
2. Plug your oven into a standard household outlet. Be sure
the voltage and the frequency is the same as the voltage and
the frequency on the rating label.
WARNING: Do not install oven over a range cooktop or other
heat-producing appliance. If installed near or over a heat
source, the oven could be damaged and the warranty would
be void.
The accessible surface may be hot during operation.
Operation instruction
This microwave oven uses modern electronic control to adjust
cooking parameters to meet your needs better for cooking.
1.Clock Setting
When the microwave oven is electrified, the screen will
display "0:00", buzzer will ring once.
1) Press " Clock " once , the hour figures will flash.
2) Turn " " to adjust the hour figures, the input time should
be within 0--23.
3) Press " Clock", the minute figures will flash.
4) Turn " " to adjust the minute figures, the input time
should be within 0--59.
5) Press " C lock " to finish clock setting. ":" will
the time will light.
Note: 1) If the clock is not set, it would not function when
powered.
2) During the process of clock setting, if you press
'Stop/Clear ', the oven will go back to the previous status
automatically.
2. Microwave Cooking
Press ''Microwave' the screen will display "P100". Press
"'Microwave" for times or turn "
you want, and "P100", "P 80", "P 50", "P 30" or
"P10" will display for each added press. Then press
11
fl ash, and
" to choose the power