Genius Audio GMP-100.4D Manual Del Usuario página 13

Idiomas disponibles

Idiomas disponibles

www.geniuscaraudio.com
11. POWER LED light
When the amplifier is switched on and in operating condition, this LED will light blue.
12. PROTECTION LED light
If the active amplifier protection mode, this LED will light red.
13. Power Input
Feed B (+) and the pole to ground (GND) use 4 AWG while the remote uses an entry-gauge 12 AWG (REM terminal is
used to turn on and off remotely the amplifier when applied to + 12V )
14. Speakers Input
The speaker terminals are nickel plated allowing connection cables maximum size 10 AWG feeding the horn. NOTE:
The configuration of each channel must be verified by qualified personnel.
15. CLIPING
The LED will indicate if there is a distortion signal, it has two phases.
1. LED Blinks or Flickers: means that a distortion signal is starting
2. Fixed LED: Total Distortion Signal
16. FUSE Protects the amplifier against possible damage of low and high voltage or short circuits
GMP-100.4D and GMP-150.4D Amplifiers models are internal (intern)
3
4
5
2
1
6
7
10
8
9
15
15
GMP-100.4D
2Ω STABLE STEREO - 4Ω BRIDGED MIN.
GMP SERIES
14
13
11 12
- 13 -
loading

Este manual también es adecuado para:

Gmp-150.4dGmp-200.4d