Tabla de contenido
Adjusting Stretch Stitch Balance
The sewing results of the stretch stitch patterns may
vary depending upon the sewing conditions, such as
sewing speed, type of the fabric, number of layers,
etc. Always make test sewing on a scrap piece of the
fabric that you wish to use.
q Stretch stitch balancing dial
w Standard setting mark
e Groove
Example: (Stitch pattern
(A)If the pattern is compressed, turn the stretch stitch
balancing dial in the direction of "+".
(C)If the pattern is drawn out, turn the stretch stitch
balancing dial in the direction of "–".
NOTE:
In normal sewing, set the dial to the neutral position,
i.e. the groove on the dial is centered with the
standard setting mark.
Replacing the Light Bulb
WARNING:
Turn the power off before replacing the light bulb.
The bulb could be HOT, wait until it has cooled down
before touching it.
To remove:
Remove the cap and setscrew.
Unhook the hook from the rear cover and remove the
face plate.
q Cap
w Setscrew
e Rear cover
r Hook
t Face plate
Pull out the light bulb from the lamp socket.
y Light bulb
u Lamp socket
To replace:
Insert the bulb into the opening of the socket.
Attach the face plate inserting the ribs and hook into
the rear cover. Secure the face plate with the
setscrew, and attach the cap.
NOTE:
Replace the bulb with the same type rated 12V, 5W
(part number 000026002).
)
q
(A)
t
e
t
w
q
74
w
e
(B)
(C)
r
y
u
Tabla de contenido
