Idiomas disponibles
Idiomas disponibles
INTENDED USE
This product is designed for heating and cooking foods in suitable pans or pots. Any other use may result
in damage to product or injuries.
COMPONENTS
A. Hotplate 1500 W
B. Hotplate 1000 W
C. Hotplate 2000 W
D. Hotplate 1000 W
E. Control panel
F. Power indicator light
G. Temperature controls
H. Brackets
I. Screws
J. Sealing strip
BEFORE FIRST USE
• Remove the product and accessories from the original packaging carefully. For disposal of the original
packaging, follow applicable legal requirements. If you have questions about correct disposal, contact
your local authority.
• Check the package contents for completeness and damage. If the package content is incomplete or
damages can be found, contact your place of purchase immediately.
• After unpacking clean the product, see chapter Cleaning and care.
• During the production product parts (hot plate) are coated with a protective film. To remove these
production residues, turn the thermostat up to the maximum position (level 6) and keep the product
in operation for about 3 minutes without pot/pan. Please ensure adequate ventilation, as this can lead
to slight odor and smoke which is harmless and will disappear after a short time.
INSTALLATION
For installation pay attention to all dimensions. Prepare a cutout of 490 x 560 mm into the work
1
plate.
WARNING! Pay attention to the safety clearances to the side and rear. When installing a hob higher
cabinets or room walls are only allowed with a 60 mm distance from the rear and 55 mm distance from
only one side (right or left). There shall be no higher cabinet or wall to the other side (right or left).
Pay attention to minimum clearances for air circulation inside the kitchen cabinet.
2
A (mm)
min. 650
WARNING! If a hood is placed over the hob, the safety distance specified by the manufacturer must
be observed.
If no manufacturer's instructions are available or combustible materials (e.g. a wall unit) mounted
above the hob, the safety distance A must be at least 650 mm.
This appliance must be earthed.
3
Minimum requirement power cord: H05VV-F 3x6mm
If possible connect the hob the mains before installing the hob to the work plate.
WARNING! Before connecting, all poles of the corresponding circuit must be disconnected from
mains supply.
The corresponding circuit shall be secured against unintentional reconnection.
The electrical connection must be done by an appropriately trained professional.
1. Remove the protective cap from the terminal.
2. Pay attention to the connection diagram and connect L, N and ground to the terminal
accordingly. Make sure that all cables are firmly fixed.
3. Put the protective cap back on the terminal.
IM_OBH16311_140925_V03_HR.indb 15
B (mm)
C (mm)
min. 100
min. 20
15
D
E
Air inlet
Air outlet min. 5mm
/3x2.5mm
2
2
EN
25/9/14 5:57 PM
