Idiomas disponibles
Idiomas disponibles
Your Dremel HSES-01 does not come
completely charged from the factory. Be
sure to charge tool prior to initial use.
-
Insert USB cable 8 into USB port of
power adapter 9 (Fig. 1).
-
Plug power adapter 9 into standard
power outlet.
-
Plug micro USB plug into Micro USB
port 5.
The battery charge indicator 3 will blink
indicating that the battery is charging.
See "Battery Charge Indicator" below
for more information.
It is normal for the handle of the tool to
get warm during charging.
Note: The tool cannot be used during
the charging process.
When the battery is fully charged,
disconnect the Micro USB end of the
cable 8 from the tool.
Unplug the power adapter from the
power outlet (unless you are charging
another tool).
BATTERY CHARGE INDICATOR
The battery charge indicator 3 will blink
at fast pace when the battery charge
falls below 30%. During charging, the
battery charge indicator will blink at
slower pace. Once the charging process
is complete, the battery charge
indicator will glow steady green light.
IMPORTANT CHARGING NOTES
-
Lithium-ion battery will hold its
charge while in storage for up to 2
years so it's always ready when you
need it.
-
The charger was designed to fast
Charging the Tool
-10-
charge the battery only when the
battery temperature is between 41˚F
(5˚C) and 113˚F (45˚C).
-
A substantial drop in operating time
per charge may mean that the battery
pack is nearing the end of its life and
should be replaced. To replace an old
battery, contact Dremel customer
service at 1-800-4-DREMEL. The
Dremel Service Center can install a
new battery and ship it back to you
within 48 hours of receiving your tool.
-
If battery does not charge properly:
a.
Check for voltage at outlet by
plugging in some other electrical
device.
b.
Check to see if outlet is connected
to a light switch which turns power
"off" when lights are turned off.
c.
Check USB terminals for dirt.
Clean with cotton swab and
alcohol if necessary.
d.
Check to see if USB cable is
properly connected to the tool and
the power adapter.
e.
If you still do not get proper
charging, send tool and power
adapter to your Dremel Service
Center.
Note: Use of power adapters or battery
packs not sold by Dremel may void the
warranty.
