Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS
MODEL:
SL2118/B
SL2118/C
Before using or installing the product, kindly read the instructions and follow safety rules. Installation should
be provided by qualified person or company.
Thank you for choosing the item of company PANLUX s.r.o.
Technical data
Power supply: 230V~50Hz
Impute fuse: 6,3A 250V
Supply in standby mode: <1W
Current: max. 5,21A
Additional load: max. 1200W (incandescent lamp)
max. 300W (fluorescent lamp)
Protection class: II.
IP Protection: IP44
Angle of detection: horizontal – 180°, vertical – 60°
Rotation of sensors head: horizontal - ±45, °
vertical – 25°
Reach: max. 12m
Time setting: 10s (±5s) to 10min (±2min),
adjustable (TIME), logarithmic scale
Twilight setting: 3-2000lx (LUX), adjustable (LUX),
logarithmic scale
Recommended installation height: 2-2,5m
Terminal block: 3x1,5mm²
Operating temperature: -5°C~55°C
Location: interiors, exteriors
Weight: 200g
Material: plastic
Remarks: relay contact on output
Installation
1
2
80mm
45°
45°
25°
120mm
Notice
Before using, check the product and make sure there is no damage,
otherwise do not use it.
Before any manipulation assure that mains electrical supply is
disconnected.
In case of damage do not repair or disassemble the product.
For the best functional results, move toward the sensor (see to pic. 6).
The incorrect function of the product can be caused by interruption of
electromagnetic field, small temperature difference between moving
object and surroundings, reflection (e.g. strong luminous source).
Infringement of any mentioned instruction can cause harm to health
or property.
72mm
45mm
52mm
230V~50Hz
42mm
Principle of PIR sensor
PIR sensor receives infra-red waves emitted by objects in reach radius. With movement in the detection area sensor notices
the change and initiates trigger order „Light on" for adjusted time.
Manual setting
Settings can be changed by an external switch from automatic to manual control and vice versa. Lamp can be switched to
a permanent position by pressing the switches twice within three seconds. The light will switch ON and then stays ON for
eight hours, afterwards return to automatic (normal) mode. The sensor can be switched back to automatic mode by next
two pushes within three seconds. The light will switch ON after approx. three seconds and returns to the automatic mode.
Reach setting (sensitivity) – max.12m
Reach is to be understood as the area traced out by angle of detection and min. to max. available distance from sensor.
Reach can be changed with rotation of sensors head.
Time setting (switch-off delay) – TIME (10s (±5s) až 10min (±2 min))
The countdown of adjusted time begins after last detected movement. We recommend setting the function on minimum
during functional test.
Twilight setting (response threshold) – LUX (3 – 2000lx)
We recommend setting the function on maximum during test.
Stated information may differ according to position and installation height.
Position marked - or applies to minimum and position marked
If the product is mechanically damaged or connected unprofessionally, guarantee cannot be allowed.
3
4
L
brown
N
blue
black
SL2118
PIR sensor 180°
or
applies to maximum.
+
180˚
5
6
60˚
12m
0,5 - 3,5m
2-2,5m
All right reserved.
Technical data can be changed without previous notice.
UM_SL2118_121122
