13
Align mounting slot holes in the Shifter Plate with the T-Nuts previously installed in Step 10.
Bolt through and secure with 4 x M8 Bolts and Washers.
14
Install End Caps.
ANGLE AND POSITION
ADJUSTMENT
A)
B)
B)
C)
C)
A) Loosen the Bolts securing the Shifter Plate. Adjust to the desired angle and position, tighten the Bolts to lock in place.
B) Loosen the Bolts securing the Shifter Arm to the Shifter Arm Support and the Wheel Post. Adjust to the desired height, tight-
15
en the Bolts to lock in place.
C) Loosen the Bolts securing the Shifter Support Arm to the Right Base. Loosen the bolts securing the Shifter Arm to the Wheel
Post. Adjust forward or backward to the desired position, tighten the Bolts to lock in place.
10
10
PARTS:
LEFT HAND SHIFTER
• • 4 x M8 16mm Bolts
MOUNT ASSEMBLY
• • 4 x M8 Washers
• • Shifter Plate
16
PARTS:
• • 2 x End Caps (40 x 40 Angled)
• • 2 x End Caps (40 x 80 Angled)
17
PARTS:
• • NIL
18
Uninstall 4 x Ratchet Handles and 2 x Seat Slider Assemblies.
Uninstall 2 x M8 40mm Bolts and M8 Washers connecting the Left Base to the Rear Base.
Uninstall the End Cap and Cable Management Clip (if installed).
Note: Use Regular T-Nuts if installing onto
Carbon Grey F-GT Elite Cockpit.
Install 2 x Full Width T-Nuts into the top and bottom channel of the Left Base.
Red dots show T-Nuts placement.
11
11
Video Instruction: bit.ly/nlrbuild
PARTS:
• • NIL
PARTS:
• • NIL
PARTS:
• • 2 x M8 Full Width T-Nuts
or
• • 2 x M8 Regular T-Nuts
(Carbon Grey Elite Cockpits only)
