Idiomas disponibles
Idiomas disponibles
1. If stool has adjustable legs (-ADJ), place stool frame down on a protected flat surface so legs are facing up.
Remove screws and star washers from leg.
NOTE: Factory provided screws and star washers MUST be discarded after removal from legs. Hardware
provided in hardware pack MUST be used to provide maximum stability of stool.
Slide inner leg up until desired height is attained, making sure holes in the inner leg align with holes in outer
leg. Slide Hardware F onto Hardware E, then into the outer and inner leg holes. Tighten completely using a
4mm Allen wrench or 4mm hex-head bit with a screw gun.
Repeat for remaining legs.
NOTE: For attaching seat to frame with backrest, see Assembly ②.
NOTE: For attaching seat to frame without backrest, see Assembly ③.
ASSEMBLY ② - HARDWOOD SEAT - ARMOR EDGE ™ SEAT - URETHANE SEAT
1. Place seat on top of frame and align the outer-most holes with the inserts/ pre-drilled holes of the seat.
2. Insert screws/bolts* through the bottom of the frame to the threaded inserts/ pre-drilled holes in the seat & tighten.
*Hardwood seat - Hardware A
*Armor Edge™ seat - Hardware C
*Urethane seat - Hardware G
wibenchmfg.com
ASSEMBLY ① - ADJUSTABLE LEGS
Specifications are subject to change. Product
images are for illustrative purposes only and may
differ from the actual product.
507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
3
