Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
1.
Shut off the water at the supply valves under the
sink or at the main water supply. Disconnect the
supply lines. Remove the existing faucet from the
sink.
Clean and dry the surface area where the new
faucet will be mounted.
2.
Confirm the hose washer (2.1) is inside the nut
(2.2) on the end of the sprayer hose (D). To attach,
twist the spray head (A) into the nut (2.2) on the
sprayer hose (D).
3.
Feed the sprayer hose (D) down through the faucet
body (B) until the sprayer hose nut (3.1) sits in the
spray head guide (3.2) on the faucet body (B).
Remove the mounting nuts (C) from the shanks
(3.3) on the faucet body (B). Ensure the gasket
(3.4) is on the bottom of the faucet body (B). Apply
a thin bead of silicone sealant to the underside of
the gasket (3.4). Carefully insert the sprayer hose
(D) into the center sink hole and the shanks (3.3)
on the faucet body (B) into the other holes on the
sink.
4.
From underneath the sink, thread the mounting
nuts (C) onto the shanks (4.1) on the faucet body
(B).
Check the position of the faucet and hand tighten
until the faucet body (B) is securely mounted to
the sink. NOTE: It is helpful to have a second
person hold the faucet in place while tightening the
mounting nuts (C).
1
2
3
D
4
4.1
4
2.2
A
2.1
D
B
3.4
3.3
C
C
