Idiomas disponibles
Idiomas disponibles
CONTROL PANEL
A
VACUUM SWITCH: This switch will illuminate when the vacuum motors are on. The vacuum motors run off of cord #1.
B
SEPARATE CIRCUIT LOCATOR LIGHT: When this light is on, it indicates that cord #2 (Identifi ed by the red "H" on the back of the extractor.)
is on a separate line from cord #1. Cord #2 supplies voltage to the heater allowing it to heat to the temperature range indicated by the Heat
Control dial (#1) on the switch plate.
C
BYPASS SWITCH: The bypass switch will illuminate when it is activated and will completely bypass the circuit locator system. Use this system
only when the circuit locator light will not turn on and you know each cord is on a separate circuit. NOTE: THE CIRCUIT BREAKER CAN TRIP
IF BOTH CORDS ARE ON THE SAME CIRCUIT AND THE BYPASS (heat) SWITCH IS TURNED ON.
D
HEAT MODE LIGHT: This light will only illuminate when the heater is heating and will turn off when it reaches operating temperature. During
normal operation, the "MODE" light will be on most of the time.
E
CARPET UPHOLSTERY SWITCH: This rocker switch activates a solenoid valve - when it is turned to Upholstery - that allows most of the
pump pressure to recirculate back to the Holding tank This allows you to clean delicate material at low psi (about 75 psi) When the switch is
set to Carpet, the pump operates without the solenoid and provides about 300 psi to the cleaning tool. The pump runs off of cord #1. The pump
spraying pressure will be observable at the pressure gauge. This switch does not light up.
F
PUMP ON/OFF SWITCH: This switch turns the pump on and off. It will light up when it is turned on.
A
E
5/08
INSTRUCTIONS FOR USE
56041967 - SOLUS
310
®
ENGLISH - A
B
C
D
F
7
