Idiomas disponibles
Idiomas disponibles
MAINTENACE
1. CHECK that the screws securing the
brackets and reduction gear are well
tightened.
2. CHECK the conditions and tightening of
the nuts which secures the steel cable
clamps.
3. CHECK periodically that motor stop
switch and push button switch are good
operating conditions.
4. CHECK periodically that the steel cable is
in good conditions.
GENERAL SAFETY RULES
WARNING:
Before using this electrical carefully read
the general safety rules listed below.
1. Your sockets must comply with safety
rules. In case your sockets are not
suitable, it should be checked by a skilled
electrician.
2. Your socket plug must absolutely be
grounded and your electric system must
be supplied safely with a magneto.
• When
the
unwatched, be careful that children
cannot reach it.
• Do not pull the electric cable to
disconnect the plug.
• The machine shall be protected from
frost and low temperatures.
3. In case the machine cannot hoist a load,
do not keep pressing the hoisting push
button: this means that the load exceeds
the machine maximum capacity.
• The machine shall not be disassembled
when running or connected to power.
• Do not stand under hoisted weights.
4. Before starting the work, make sure that
the steel cable is correctly winded around
the reel and the pitch is equal to the
machine
is
running
cable diameter.
5. Observe the maximum load indicated on
the hoist and don't exceed it.
6. Leave at least three turns of cable around
the reel, so that the cable connection is
not under stress.
• To avoid any danger, do not wind
more than 15 m of cable around the
reel.
7. In case the steel cable is worn out, it must
be replaced only with a cable of same
features.
• Before starting the work, check
that switches are in good operating
conditions.
8. In case the hoist stops during the
lowering of a load, it is normal that the
load goes down a few centimeters more
because of inertia.
9. Attention: The hoist electric motor is
not supplied with an overload cut-out
(to avoid an unexpected and unwanted
restart) therefore, if you are unable to
hoist a load do not insist and let the
motor cool down.
E N G L I S H
3
