Idiomas disponibles
Idiomas disponibles
Important-Safety Precautions
• To prevent fire or shock hazard, do not expose this
product to rain or moisture. do not use near a bathtub, wash
bowl, kitchen sink, or laundry tub, in a wet basement, or near
a swimming pool.
• To avoid electrical shock, do not open this product.
• This product should be operated to use the power supply
must have the same voltage as the local area.
• Do not overload wall outlets and extension cords as this can
result in the risk of fire or electrical shock.
• Refer servicing to qualified personnel only.
Caution: Changes or modifications not expressly
approved by the Party responsible for compliance could
avoid the user's authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
1
A. Checking Contents of Box
Check to ensure all of the components shown as below are
included with your wireless IR remote control extender
system. If something is missing, please contact your dealer
as soon as possible.
1. Transmitter
2. Receiver
3. IR extender to connect to
receiver ' s rear panel
4. Power adapter
230VAC to 9VDC
DC in Jack (9V 150mA)
×1
×1
×1
! ×2
2
