Idiomas disponibles
Idiomas disponibles
d) Differential setting
Differential ¾ of a turn
e) Adjusting the cutting height (minimum 3cm).
Set the cutting height with the adjustable skids. The closer the bar is to the ground, the better
the cut.
Lock the skids firmly in the chosen position..
VI. USE
a) Inspection before use
- Make sure that the 4 bolts (16) that hold the bar are well tightened, and also the 2 bolts that connect
the blade to its traveller.
- Only work with blades that are sharp and in good condition. Remember that each part of the blade
can be replaced separately.
- Do not work if any section is loose or badly riveted.
b) Use
- Disengage the drive clutch. When the lever is open, the clutch is disengaged.
- Disengage the blade clutch by pulling back the lever on the bottom right.
- Squeeze the dead man's handle and hold it against the handlebar.
- Set the accelerator to the "hare" position (choke).
- Pull the starter hard to start the engine. If this does not work, refer to the engine instructions.
- Move the accelerator from the choke position to the acceleration position. The machine is
now ready to mow.
- Engage the blade by pushing the lever placed low-down on the right forwards and inwards,
engage forward gear and maintain it in position using the handle. To move the machine
without cutting, disengage the blade.
- For work needing a precise finish, manoeuvre the machine by hand
8 EN
Differential locked
.
