Sony Bravia XBR-85X800H Guía De Referencia página 11

XBR-49X800H / 43X800H only
Attach the Wall-Mount Bracket (not
supplied) using the screws (not
supplied).
Wall-Mount Bracket
Note
• If using an electric screwdriver, set the torque at
approximately 1.5 N·m {15 kgf·cm}.
Detaching the Table-Top Stand from the
TV
1
Remove one side of the Table-Top
Stand at a time. Firmly hold the
Table-Top Stand securely with both
hands while the other people lift up
the TV.
2
Repeat the previous step and remove
the other side of the Table-Top Stand.
Note
• Three or more people are required to detach
the Table-Top Stand.
Screw
XBR-49X800H / 43X800H only
To detach the Table-Top Stand from the
TV, remove the screws.
• Be careful not to use excessive force while
detaching the Table-Top Stand from the TV as
it may cause the TV set to fall resulting in
personal injury or physical damage to the TV.
• Take care when handling the Table-Top Stand
to prevent damage to the TV.
• Be careful when lifting the TV as the
Table-Top Stand is detached, the Table-Top
Stand may topple over and cause personal
injury.
• Take care when removing the Table-Top Stand
from the TV to prevent it from falling over and
damaging the surface that the TV is sitting
on.
• Do not remove the Table-Top Stand for any
reason other than to install corresponding
accessories on the TV.
• Be sure the TV is vertical before turning on. To
avoid uneven picture uniformity do not
power on the TV with the LCD panel facing
down.
Note
• Do not remove the Table-Top Stand for any
reason other than to install corresponding
accessories on the TV.
• Be sure the TV is vertical before turning on. To
avoid uneven picture uniformity do not
power on the TV with the LCD panel facing
down.
• When attaching the Table-Top Stand again,
be sure to fasten the screws (previously
removed) to the original holes on the rear of
the TV.
• Place the TV with its screen facing down on a
level and stable surface covered with a thick
and soft cloth when removing the Table-Top
Stand from the TV to prevent damaging the
surface of the LCD display.
US
11 US