Environmental Guidelines And Recommendations - Schulz AIR Plus Spray Split Manual De Instrucciones

The spraying is very thick
The paint or varnish jet pulses
Paint or varnish fl ows on the
applied surface
Excessive mist of paint or varnish
(excessive spraying)
Paitn or varnish in the cooling
pipe
The equipment does not turn on

12. ENVIRONMENTAL GUIDELINES AND RECOMMENDATIONS

1. Wastewater Disposal
The presence of untreated wastewater into rivers, lakes or other water receiving bodies may adversely affect
marine life and water quality.
Schulz Compressores S.A. recommends correct treatment of wastewater through processes that ensure envi-
ronmental protection and healthy quality of life in conformity with the regulatory requirements of the current
legislation.
2. Disposal of Solid Waste (large parts and product packaging)
The generation of solid waste is one aspect that must be considered by the user in the use and maintenance
of the equipment. The impacts on the environment may cause signifi cant changes in the quality of the soil, in
surface and underground water, and in the population's health due to improper disposal of the discarded waste
(on streets, water receiving bodies, landfi lls, vacant lots, etc).
Schulz Compressores S.A. recommends that the waste resulting from the product, from its generation, use, trans-
portation, and treatment to its fi nal disposal, be handled with care. A suitable management should consider the
following stages: quantifi cation, qualifi cation, classifi cation, reduction at source, pick-up and selective pick-up,
recycling, storage, transportation, treatment and fi nal destination. Waste disposal should be done in compliance
with the requirements of local legislation in effect.
The fi nishing material features an excessive viscosity
The regulation is far to the right ( + )
The nozzle is dirty
The air fi lter is with dirt excess
The container pressure is insuffi cient
The material is ending
The air fi lter is very dirty
Paint or varnish has been applied in excess
The sprayed surface is very far
The diaphragm is dirty
The diaphragm is damaged
The equipment is overheated
41
Dilute the material
Turn the regulator to the right (-)
Clean it
Replace it
Retighten the container
Refi ll it
Replace it
Turn the regulator to the left ( - )
Reduce the spraying distance
Clean the diaphragm
Replace the diaphragm
Remove the inlet from the
electrical grid, let it cool.
Check the air fi lter