BEA KMR AC/90-942C Instrucciones página 15

Device-specific additional instructions for nailer
8 Removing stuck fasteners from the driving channel
Disconnect the tool from the compressed air supply. Open the magazine as described in chapter 4 and
•
remove the nails. Use pliers to remove jammed fasteners from the magazine. Then reconnect the tool to the
compressed air supply and refill it with nails
9 EU Declaration of conformity
The BeA GmbH, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's conformity with all
relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 8662 (Vibrations at driving tools).
------------------------------------------
Dr. Jörg Dalhöfer, CEO
AC/90-942C
-----------------------------------------------------------
Joachim Bauer, Documentation responsible
EN - 15