Idiomas disponibles
Idiomas disponibles
Troubleshooting
The dust extractor S 36 Propane / T 8600 Propane is
designed and manufactured for severe environments
and tasks, but the user must note that the product must
be protected from knocks and blows. Filter, seals,
Issue
Engine doesn't start
Fan impeller not engaging
Engine and fan runs but there is no suction
Engine and fan runs but suction is poor
Dust blown from motor
Abnormal noise
Transportation of the product
•
Secure the product during transportation in order to
avoid transport damage and accidents. Use the
factory installed tie down lugs on the machine, to
prevent movement during transport.
570 - 003 - 07.06.2018
TROUBLESHOOTING
TRANSPORTATION AND STORAGE
attachments, and connections are carefully adapted and
selected with regard to the operator's work environment.
Therefore, the operator and service personnel must treat
the dust extractor with care in order for it to work
correctly for many years.
Cause
No gas
No spark
No battery power
Switch defective
Low oil sensor
Emissions sensor
No cranking
Worn/broken clutch
Hose not connected
Hose clogged/blocked
No plastic bag
Damaged hose
Filter clogged
Loose top cover
Dirt in the flap
Wrongly assembled or dam-
aged filter system
•
During transportation, battery and propane tank must
be securely fastened and completely disconnected
at all times.
•
If the engine has been running, allow it to cool for at
least 15 minutes before loading the engine-powered
equipment onto the transport vehicle. A hot engine
and exhaust system can burn you and can ignite
some materials.
Solution
Replace gas tank, check fuel
hose and regulator
Check engine service manual
Replace with a fully charged
battery
Replace
Check oil level and refill if nec-
essary
Ventilate area and wait until red
light on sensor is off
Check fuse
Check and change fuse if nec-
essary
Connect hose
Clean hose
Install plastic bag
Replace hose
Clean filter/Replace filter
Adjust
Clean the flap
Adjust/Replace filters
Order service
11
