Idiomas disponibles
Idiomas disponibles
English
Clock Setup
Manually setting the clock can only be done in STANDBY mode.
1. In STANDBY mode, long press the Tuning knob.
2. Rotate the Tuning knob to adjust between the 12 or 24 setting. Press Tuning
knob to confirm.
3. Rotate the Tuning knob to change the hour digits to the correct hour. Press
the Tuning knob to confirm.
4. Rotate the Tuning knob to change the minute digits to the correct minute.
Press the Tuning knob to confirm
Stereo System Connection
When used as a line output, the jacks output analog line-level signals and could
be connected directly with a pair of active speakers or the appropriate input of
your stereo system.
Aux Input Connection
You can connect an audio device to this unit and play your music through its
speakers. To do this, press the Aux button, connect the 3.5 mm auxiliary cable
between your audio device, and the Aux In Jack of this unit and start playing the
music.
Turntable Operation
1. Press the On/Off Volume Knob to turn on the power.
2. Press the PHONO button.
3. Set the Speed Switch accordingly.
4. Place the record on the turntable. Use the 45 RPM Adapter if necessary.
5. Remove the stylus protector from the stylus assembly.
Note: To avoid stylus damage, make certain the included stylus guard is in place
whenever the turntable is being moved or cleaned.
6. Release the tonearm Hold Down Clip.
Note: When the turntable is not in use, remember to lock back hold down clip.
7. Use the Tonearm Lever to lift up the tonearm.
8. Gently move the tonearm over the record where play is desired to begin. Set
the Tonearm Lever back to the down position, the tonearm will descend
slowly onto the record and begin to playback.
9. When the record is finished playing, use the Tonearm Lever again to raise the
tonearm and then return it to the Tonearm Rest. Release the lever to let the
tonearm sit back at its rest. To suspend the playback, repeat the same steps.
10. 10. Lock the Tonearm Clip to secure the tonearm.
6
