Idiomas disponibles
Idiomas disponibles
Damage caused by disregard of certain guidelines in this manual is not
covered by the warranty and the dealer will not accept responsibility for
any ensuing defects or problems.
4. Features
compact 3.5" high-resolution TFT screen
camera with IR LEDs
5. Overview
Refer to the illustrations on page 2 of this manual.
A
display
B
mounting bracket
C
video cable
6. Installation
Refer to the illustrations on page 2 of this manual.
1.
Make sure the vehicles' engine is off and power is removed from the
electrical system. Disconnect the battery and remove the ignition key
from the ignition switch.
2.
Mount the LCD [A] with the mounting bracket [B] on the dashboard
using the double sided tape on the bottom of the bracket.
Make sure the driver has a clear view on the monitor.
3.
Connect the monitor cable [D] to the monitor. The connector fits in
only one way, do not force.
4.
Guide the video cable [C] to the back of the car where the camera will
be mounted.
5.
Drill a hole (Ø28mm) in the bumper (drill not included).
6.
Insert the cables [5, 6] and the camera [G] into the hole.
Depending on the location of the camera, use the adjustment rings to
level the camera with the surface of the bumper. Use the nut to secure
the camera. Do not tighten it yet.
7.
Connect the video cable [C] to the camera [5, yellow]; connect the
other end to the monitor cable [D2, yellow].
8.
Connect the red wire [3] of the monitor cable [D] to the cars +12V
electrical circuit, at a location where there is only power once the
ignition key is turned (run circuit).
9.
Connect the black wire [4] of the monitor cable [D] to ground (GND).
10. Connect the red wire [3] of power cable [E] to the reverse light circuit
(+12V).
11. Connect the black wire [4] of power cable [E] to ground (GND).
12. Connect the other end of power cable [E] to the camera [6, black].
V. 01 – 18/03/2013
CAMSET31
D
monitor cable
E
adjustment rings
F
camera
4
©Velleman nv
