Idiomas disponibles
Idiomas disponibles
Frequently asked questions, answers and connection
diagram for PNI MAB300LR
Q1. Does the battery connect directly to board connectors 8 & 9 ? What
type of battery is compatible? Does the board charge battery?
A: You can connect 2 pcs. 12V 7AH, 9AH or other Ah backup batteries that
are compatible with the board. When the board is connected to a 230 V
power supply it will keep the battery charged. When 230V power fails, the
battery will power the board.
Q2. What is the connection diagram between Board and IR sensor/photocell
( 5, 6, 7 connectors)
A: You can find the diagram below
Q3. What is the 10 connector from PCB used for?
A: 10 connector VCC port is one output power supply terminal with about
24 – 27 V.
Q4. Mainboard has COM and GND descriptions. Are they the same?
A: Yes, COM = GND
Q5. How do the 1 & 2 input ports work? What type of external device can
control the gate through these ports?
A: ports 1, and 2,3 are for input signals for other open devices, such as push-
button, GSM modules, external receivers etc.
Port 1 --- 2SIDE, this is the terminal where you can connect an external
device to trigger both gates' open-stop-close cycle.
Port 2-- COM
Port 3-- 1 SIDE, this is the terminal where you can connect an external device
to trigger a single gate open-stop-close cycle.
Q6. Is there a difference between port 1 input and port 4 input? What type
of device can be connected to port 4?
A: 2SIDE terminal input is for connecting many external devices that will
control both gates. Port 4 input can receive commands from a swipe card
terminal, and a wired keypad and can also only control both gates and it has a
self-close timer.
17
User manual
