T EC HN IC A L I N F ORMAT IO N
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Max. flow rate
Hole size in mounting surface
Max. depth of mounting surface
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
I NSTA LL AT I O N CO N SID E R ATI ONS
⁄ For best results, Hansgrohe recommends that this unit
be installed by a licensed, professional plumber.
⁄ Inspect this faucet thoroughly before installation.
Claims for shipping damage made after installation
will not be honored.
⁄ Please read over these instructions thoroughly before
beginning installation. Make sure that you have all
tools and supplies needed to complete the installation.
⁄ 36110XX1, 36121XX1 ONLY: The drain is suitable
for most, but not all, lavatory sinks sold in the United
States and Canada.This drain is intended for use in
a sink with an overflow. If your sink does not have
an overflow, or if this drain is too small for the hole
in your sink, please refer to the instructions included
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
1.2 GPM (4.5 L/min)
1⅜" (36 mm)
1⅜" (35 mm)
E N G L I S H
with the sink. Some sinks include special drain instal-
lation instructions and/or parts. Others require the
use of a specialty drain. Hansgrohe is not respnsible
for the cost of a specialty drain.
⁄ Models 36113XX1 and 36111XX1 include neither
drain nor pull rod.
The hot and cold supply hoses included with
this faucet are for use with ⅜ stops. If your
stops are a different size, install new stops.
Adapters are not available from Hansgrohe.
⁄ Keep this booklet and the receipt (or other proof of
date and place of purchase) for this product in a safe
place. The receipt is required should it be necessary
to request warranty parts.
