Idiomas disponibles
Idiomas disponibles
90550107 PC1800ID, PC1200ID
Symbols
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V..................volts
Hz................hertz
min ..............minutes
............direct current
................Class I Construction
(grounded)
................Class II Construction
(double insulated)
IPM.............impacts per minute
This product can accept any of the batteries and chargers listed in the chart below.
LI-ION Battery Packs and Chargers
Description
Battery:
LI-ION 18V
Charger: LI-ION
FUNCTIONAL DESCRIPTION
Figure A
1. Trigger switch
2. Forward/Reverse button
3. Chuck collar
4. 1/4 inch hex quick-release chuck
5. LED Work Light
6. Bit storage
7. Belt hook (optional accessory)
8. Battery (not included)
9. Battery Release Button (on
battery)
• When using an extension cord, be sure to use one heavy enough to carry the current
your product will draw. An undersized cord will cause a drop in line voltage resulting
in loss of power and overheating. The following table shows the correct size to use
depending on cord length and nameplate ampere rating. If in doubt, use the next
heavier gage. The smaller the gage number, the heavier the cord.
Recommended Minimum Wire Size for Extension Cords
Total Length of Cord
25 ft.
50 ft.
7.6 m
15.2 m
Wire Size AWG
18
18
4/1/09
9:33 AM
Page 5
A ..................amperes
W..................watts
................alternating current
n o ................no load speed
..................earthing terminal
................safety alert symbol
.../min or rpm ....revolutions or reciprocation
BPM ............beats per minute
NI-CD Battery Packs and Chargers
Cat. #
Description
PC18BL
Battery: NI-CD 18V
PC18BLX
NI-CD 12V
PC18BLEX
Charger: NI-CD
PCLMVC
PCXMVC
A
4
3
5
75 ft.
100 ft.
125 ft.
22.9 m
30.5 m
38.1 m
16
16
14
5
per minute
Cat. #
PC18B
PC12B
PCMVC
PCXMVC
2
1
6
9
7
8
150 ft.
175 ft.
45.7 m
53.3 m
14
12
