Nylon String - Tramontina AP300 Manual De Uso

FORM OF usagE
Keep the switch pressed down and lift the trimmer about 3 cm from the ground. In this position move slowly
the trimmer from one side to another to promote the trimming of the grass.
Never use the trimmer without the protector or when it is damaged, since the protector helps in the refrigeration
of the motor, limits the length of the nylon string and is a safety device for the operator.
It is recommended to give an interval for rest of 2 minutes after 15 minutes of continuous use, thus ensuring
greater useful life to the motor and thus preventing an overload.
iMpORtant!
This equipment is recommended for occasional use (domestic use) in lawns of up to 50 square meters (AP300
model) and 100 square meters (AP500, AP600, AP700, AP800 and AP1000 models), to do the outlines, edges
and corners. The area may be larger or smaller depending on conditions of use: type of grass, height of grass,
the temperature, humidity, etc.
Do not use on humid or wet grass.
iMpORtant!
Do not overload the trimmer by entering into tall grass. If needed, carry out several cuts starting on top and going
down to smaller cuts.
Inspect and perform maintenance regularly on the trimmer. Any maintenance must be performed by an authorized
technician.
MAintenAnCe
For any maintenance and control operation, the electric cable must be disconnected from the outlet.
instRuctiOns FOR WastE DispOsaL
Improper disposal of solid waste can cause serious damage to the environment, including soil and water contamination.
Therefore, solid waste should be separated and discarded properly. Recyclable waste materials should be recycled.
spOOL REFiLL
[Fig 6].
Keep the spool housing (1) fixed and turn the top cover of the spool (2) in the counterclockwise direction
Remove the used spool (3) and place the new spool, causing the string to pass through top cover output opening
[Fig 7].
of the spool
Then replace the assembly (top cover and spool) (4) pressing it against the spool housing (1), and turning it in the
[Fig 8].
clockwise direction until the latch snaps
nyLOn stRing RELOaD
iMpORtant!
Use only nylon string in the recommended diameter 1.6 mm and length of 8 meters. The spool can be reloaded,
as follows:
ap300
Remove the spool (3) and the spool protection clamp (4) and coil the string. Then pass the nylon string through
the protection clamp. Replace the protection clamp on the spool and then the spool in the trimmer's spool holder
[Fig.13].
ap500, ap600, ap700, ap800 and ap1000
[Fig 9].
Fit the string into the spool opening (1) according to figure
[Fig 10]
coil the string in the direction indicated by the reel's arrow (2) as uniformly as possible,
14
obeying 8 metres as the maximum length recommended.