Idiomas disponibles
Idiomas disponibles
8.
Hang the luminaire on the mounting hooks. (Figure 6)
Figure 6.
9.
Close and secure the driver box, by screwing back the
driver box screws. Torque the screws to a maximum of
13 in-lbs. Adjust back the luminaire head to downward
position. (Figure 7)
Figure 7.
10. Using the 2 top back hanging screws of the fixture,
temporarily hang the fixture on the bottom hooks of
the mounting plate to safely make appropriate electrical
connections by following the wiring diagram, use
electrical connectors. Carefully tuck all the wires and
connectors into the J-box. (Figure 8,9)
Figure 8.
Black
White
Green/Yellow Green
Figure 9.
11. Pull up and detach the fixture. Position it to the
mounting plate using all the back top, bottom and
side hanging screws into the appropriate hooks of the
mounting plate (top to top, bottom to bottom, side to
side). Secure the fixture by tightening the two side
retaining screws. (Figure 10).
Figure 10.
12. Applying silicone caulk around the perimeter of the
driver box where it meets the wall to ensure a water-
tight seal. Finally adjust the fixture head angle according
to project needs and secure it by locking the side
philips head screw. (Figure 11)
Figure 11.
After installation
After Installation Is Complete, Please Check The Following:
1.
Ensure the lighting fixture is firmly fixed to the wall.
2.
Ensure wires are connected correctly before applying
power.
3.
At last, turn on the power, and check if the lighting
fixture works properly. If not, turn off the power and
contact your local dealer.
Line
Cleaning And Maintenance
Neutral
CAUTION: Be sure fixture temperature is cool enough to
Ground
touch. Do not clean or maintain while fixture is energized.
1.
Clean lens & fixture with non-abrasive cleaning solution.
2.
Do not allow LED modules or other electronics to come
into contact with water, solvents, or other chemicals
3.
Clean the diffuser only with a mild soap and water. Do
not use solvents such as alcohol or bleach.
4.
Clean painted surfaces only with a mild soap, isopropyl
alcohol, or acetic acid solution.
Cooper Lighting Solutions
Installation Instructions – ASWP
Silicone caulk
IB51443022
Installation instructions
Tight
3
