Power Dynamics PDWS2 Manual De Instrucciones página 4

UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
MOUNTING THE VOLUME CONTROL
The volume control is designed to be mounted in a DIN 49073 electrical wall
box, with a depth of at least 50mm (the package includes a universal wall
mount box too).
Select a location that is within reach of the speaker wires and easy to
reach when wanting to operate the volume control. Measure accurately before
initiating the cutting/sawing/drilling process!
Warning: Do not mount the volume control directly on a wall!
CONNECTIONS
1. Connect the speaker cable to the speaker control:
A. Strip 6mm of insulation from the end of each cable.
B. Tightly twist the wires in each cable until there are no frayed ends.
C. Insert the 4 speaker cables from the amplifier into the input area.
D. Insert the 8 speaker cables (as you can see below in the picture)
2. Screw box into place.
Put the ABS faceplate on.
4