Carrying Out Measurements - Welby 14942 Manual De Instrucciones

USA

Carrying out measurements

Carrying out measurements
− Press the button to switch on the device.
NOTICE!
If the cuff pressure exceeds 300 mmHg (40 kPa) or other errors (
notification) are indicated on the display, stop the measurement by
removing the cuff or pressing the button.
All functions or icons will be shown briefly
on the display. The cuff is inflated and the
measurement begins. The date, time and the
current diastolic blood pressure is displayed
and the pulse icon flashes.
− Press the button to abort the
measurement.
The cuff deflates.
− If you want to repeat the measurement, you should wait a few
minutes. To start the measurement, press the
NOTICE!
If the icon flashes, the cuff is not sitting correctly and will not
be sufficiently inflated.
− In this case, repeat the measurement.
The cuff deflates when the measurement is complete. The
systolic and diastolic blood pressure and the pulse are shown on
the display. In addition, the bar chart on the right of the display
also shows the classification of the measured blood pressure
(see "Improper use").
− Press the button to switch off the device. If the button
is not pressed within three minutes, the device will switch
off automatically.
24
866-633-4660
USA
ERR
button again.
AFTER SALES SUPPORT
[email protected]