Idiomas disponibles
Idiomas disponibles
3. Place the tank seat on the ground and place a 20 lb LP
gas tank into the designated area in the center. Once
the tank is level and steady, tighten down the screw on
the side of the tank seat to secure the tank in place.
4. Connect the LP Gas Tank
Before connection, be sure there is no debris caught in the
collar of the LP gas tank, the regulator valve, the burner
tube, or the burner ports.
Connect the gas line to the tank by turning the connection
knob clockwise. Hand-tighten only.
Disconnect the LP Gas Tank
To disconnect the LP gas tank, make sure the valve on the
LP gas tank is completely closed.
Disconnect the connection knob by turning it counterclockwise
until it is detached from the valve.
WARNING
!
Place the LP gas tank 56 inches (142.2 cm) away from the
fireplace and position the hose away from pathways or
places where it could become damaged.
Watch your step while moving between the tank and the
fireplace. Be careful not to trip on the hose.
WARNING
!
If the table is installed with a portion of the
hose under the table, the hose must be
secured, so that no part of the hose will be
within 1" or come in contact with the
underside of the burn pan or where the hose
will not be accidentally damaged or pinched.
Failure to secure the hose in a safe location
may result in a gas leak that could cause
property damage, injury, or death. Follow
all other hose inspection instructions
listed in this manual.
ASSEMBLY INSTRUCTIONS
56"
Coil near a corner that is
adjacent from the valve.
8
56"
Valve
The hose should not come within 1"
1"
from the bottom of the burn pan.
Do not coil the hose
beneath the valve.
