Makita 9557PB Manual De Instrucciones página 7

► 1. Wheel guard 2. Bearing box 3. Screw
CAUTION:
• When using a depressed center grinding wheel/
Multi-disc, flex wheel, wire wheel brush, cut-off
wheel or diamond wheel, the wheel guard must
be fitted on the tool so that the closed side of the
guard always points toward the operator.
Mount the wheel guard with the protrusion on the wheel
guard band aligned with the notch on the bearing box.
Then rotate the wheel guard around 180 degrees. Be
sure to tighten the screw securely.
To remove wheel guard, follow the installation proce-
dure in reverse.
Installing or removing depressed
center grinding wheel/Multi-disc
1
2
3
► 1. Lock nut 2. Depressed center wheel/Multi-disc
3. Inner flange
WARNING:
• Always use supplied guard when depressed
center grinding wheel/Multi-disc is on tool.
Wheel can shatter during use and guard helps
to reduce chances of personal injury.
Mount the inner flange onto the spindle. Fit the wheel/
disc on the inner flange and screw the lock nut onto the
1
spindle.
To tighten the lock nut, press the shaft lock firmly so
that the spindle cannot revolve, then use the lock nut
2
wrench and securely tighten clockwise.
1
3
2
► 1. Lock nut wrench 2. Shaft lock
To remove the wheel, follow the installation procedure
in reverse.
WARNING:
• Only actuate the shaft lock when the spindle is
not moving.
Installing or removing flex wheel
(optional accessory)
1
► 1. Lock nut 2. Flex wheel 3. Back up pad 4. Inner
flange
WARNING:
• Always use supplied guard when flex wheel is
on tool. Wheel can scatter during use and guard
helps to reduce chances of personal injury.
Follow instructions for depressed center grinding wheel/
Multi-disc but also use back up pad over wheel. See
order of assembly on accessories page in this manual.
7 ENGLISH
2
3
4