Idiomas disponibles
Idiomas disponibles
READ AND FOLLOW ALL ASSEMBLY, OPERATING, AND
SAFETY INSTRUCTIONS CAREFULLY. AT LEAST TWO (2)
ADULTS ARE NEEDED TO PUT THIS TABLE TOGETHER!
Figure 1
2.
Attach Strut Tubes (#17) and Linkages (#16) to Caster Beam Assemblies (#7) as shown in Figure 2.
a)
Loosen
Bolts (
#13) and Nuts (#28) so that Strut Tube (#17) can fit between Support Plate (#43)
and Caster Beam (#7) as shown in the Top View and Figure 2.
b)
Slide one Hex Bolt (#27) through inner
(#39), Strut Tube (#17), one Plastic Washer (#39), pass through Caster Beam (#7), outer Support
Plate (#43) one Spacer (#36), one Linkage (#16), and Lock Nut (#28).
c)
Repeat on other end of Caster Beam (#7) and on second Caster Beam.
d)
Tighten
Bolts
(#13) and Nuts (#28) securely.
e)
Tighten Nuts (#28) on Bolts (#27) securely.
NOTE:
Tighten nuts so that end of Bolt (#27) in even with the edge of nut.
Note: Linkages & Strut
tubes must be turned as
shown or table will not
operate correctly.
7
Figure 2
28
31
7
32
Support Plate (#43)
16
28
43
13
43
36
1. Attach Wood Bottom Board (#15) to Caster Beam
Assemblies (#7) as shown in figure 1. Turn Caster
Beams as shown and attach board with four
Carriage Bolts (#31) and four Wing Nuts (#32).
Tighten Thumb Screws securely.
Note: Support Plate (#43)
must be on inside of Caster
Rail (#7) as shown.
43
15
, followed by one Plastic Washer
17
7
27
3
31
7
32
Top View
27
(Inner Plate)
43
28
39
12
43
(Outer Plate)
13
7
36
28
17
16
