Idiomas disponibles
Idiomas disponibles
Reset to zero
The force sensor comes pre-calibrated, however, after
use you may find that the sensor is slightly off because of
changes in its position; or you may want to run an
experiment that requires you to zero the sensor with a
constant applied force on it.
To zero the sensor:
1. Connect
computer/tablet/smart device following one of the
guides below.
2. Open the NeuLog application.
3. When your sensor has been detected, click on the
force sensor module box (on the left side of your
screen).
4. Click on the "extra command" button.
5. Remove all force from the sensor and click "Reset" to
zero your force sensor.
6. You can also reset the sensor to zero by pressing
and holding the sensor push button for 3 seconds.
7. Your force sensor is now reset to zero.
Note: You can zero the scale with a constant force being
applied to it to set that value as your new "zero".
V2018.01
19
the
NUL-211
force
sensor
Home
to
a
English
