Idiomas disponibles
Idiomas disponibles
Product Specification
Component
Rated Speed
Displacement
Cutting Width
Height Adjustment
Wheels
Machine Weight
Safety & Instruction Decals
Important: Safety &
instruction decals are
located near areas of
potential DANGER.
Replace damaged decals.
1. WARNING: Read the Operator's Manual.
2. Thrown Object Hazard: Keep bystanders a safe distance
from the mower.
3. Cutting/Dismemberment Hazard of Hand or Foot, Mower
Blade: Disconnect the spark plug wire and read the
instructions before servicing or performing maintenance.
4. Cutting/Dismemberment Hazard of Hand or Foot, Mower
Blade: Stay away from all moving parts and keep all
guards and shields in place.
5. Cutting/Dismemberment Hazard of Hand or Foot, Mower
Blade: Do not mow up and down slopes, only mow
across; stop the mower and engine, pick up debris before
operating; look behind and down before reversing.
Setup
Important:
Remove and discard the
protective plastic sheet that covers the engine.
1. Unfolding the Handle
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
Do not pinch or bend cables when folding or unfolding
•
the handle.
If a cable is damaged, Contact an Authorized Service
•
Center by calling 866-591-8921.
1. Remove the handle knobs from the mower deck.
Important: Route the cables to the outside of the handle as
you install the handle.
1. Handle knob (2)
2. Move the handle to the operating position.
3. Install and tighten the handle knobs that you removed
in step 1. (Figure 1)
Specification
2800RPM
150cc
20"
1"- 3"
7" Front 11" Rear
60 lbs
WARNING
1
Figure 1
2.Attaching Wheels (See Figure 2)
Parts needed - 2 front wheels (7"), 2 rear
•
wheels (11"), 4 washers and 4 nuts.
Install the washer into wheel axle then put
•
on the wheel into wheel axle.
Screw lock nut into the end of the thread of
•
the wheel axle until it locks into place.
• Then place wheel cover by tapping it in.
Repeat process on the other side of the
•
lawn mower to install the other three wheels.
2. Filling the Engine with Oil
Your mower engine does not come filled with oil. Use
SAE 30 weight engine oil (not included)
1. Remove the dipstick.(Figure 3)
2. Slowly pour oil into the dipstick/fill hole until the oil level
reaches the full range on the dipstick. Do not overfill.
Max 13.5oz. (0.4L), type: SAE 30 weight engine oil
with an API service rating of SF or higher.
3
Figure 2
Figure 3
