Idiomas disponibles
Idiomas disponibles
These instructions contain important information on the installation and the use of the QC201
unit. Please keep them even after installation. Do not start installing the QC201 unit without having
first read these instructions. The installation can only be done by a qualified technician. In order to
conform to the rules in force, the installation must include on its power supply line a differential
magnetothermic switch with minimum distance between the contacts of at least 3mm. The security of
the product depends on a correct installation. Be at a far distance from shutter/awnings in movement.
Check frequently if any loss of balance, sign of wear or damages wires are shown. Do not use if any
repairing or maintenance is needed.
GAPOSA declines all responsibility in case of improper use of the product or of an incorrect installation.
The product has been made respecting the European norms: 2006/95/CE (CEE73/23, CEE93/68),
2004/108/CE (CEE89/336), CEE89/106, CEE89/392, EN60335-1 04/1998, EN60204-1 09/1993, EN55014-1
4/1998.
IMPORTANT! All connections must be made while power supply is cut off!
TURN THE MAIN SWITCH OFF before any other operation!
Power supply
Max Motor power
Exit 24V~
Exit 12Vcc
AUX exit
Frequency
Coverage (int/ext)
Channels
Flashing light QC201
Protection fuse
Protection rate
Working temperature
Dimensions
230 Vac ± 10% - 50/60Hz (singlephase)
800 W
terminals 11 - 12, MIN 20 Vac, MAX 26.5 V~
terminals 9 (+) - 3 (GND), MIN 9.5V, MAX 12.5 V
terminals 13 - 14, 250V - 2A, resistive load - potential-free contact NO
433.92 MHz
20 m / 200 m
62
230 V~ - Max 25 W (autolamping)
4A (delayed)
IP54
-10°C / +50°C
230 x 140 x 70 mm
Maximum current (12V / 24V~)
Loading condition
24V~
Case 1
0mA
Case 2
70mA
Case 3
140mA
12Vcc
50mA
40mA
10mA
3
