Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTION
ADJUSTING THE TRIPOD (FIG 2)
1. Loosen the tripod locking knob (F).
2. Push down the leg connector (A) until the legs (B) are fully extended
and firmly tighten the locking knob (F).
3. Adjust the height of the tripod by loosening the twist collars (C) and
raising the center poles (D) of tripod. Firmly tighten the twist collars
when the tripod reaches the desired height.
NOTE
: The maximum height of this tripod is 49".
ATTACHING CARRYING HANDLE TO
STAND (FIG 2)
1. Place the carrying handle (1) vertically on the stand (7).
2. Use two locking knobs (10), flat washers and spring washers to
secure the carrying handle to the stand as shown in FIG 2.
ATTACHING WORK LIGHT HEADS TO
STAND (FIG 2, 3)
1. Place the stand (7) on a flat surface.
2. Use the locking knobs (8), flat washers and spring washers to
secure both work light heads to the sides of the stand as shown in
FIG 2.
3. Use a twist knob (12) to attach the power cable connector (13) to
the carrying handle as shown in FIG 3.
ATTACHING THE WORK LIGHT
ASSEMBLY TO THE TRIPOD (FIG 2)
1. Place the work light assembly on the top of the tripod. The bottom
of the stand cross bar needs be sitting in the bracket (E).
2. Use the locking knob (11) to secure the work light assembly to the
tripod as shown in FIG 2.
English
9
8
FIG 2
12
FIG 3
4
1
2
10
10
11
7
E
D
C
D
C
A
F
13
1
2
9
8
B
