Idiomas disponibles
Idiomas disponibles
INSTALLATION AND SET UP FOR HOMEAWARE™
HA360DB – Doorbell Transmitter Continued
Step 1) Installation with No Existing Doorbell Chime Box Continued
d) Now that the doorbell unit is installed over the mounting block and in place, you now can install the
long screw in the top hole, and replace the screw cover.
Step 2) Installation to Existing Powered Door Chime
With this method you can install the HomeAware™ transmitter to your existing AC powered doorbell
chime. This method allows you to use the existing doorbell button so there aren't two buttons outside.
Use the provided connector wire to connect the doorbell transmitter to your existing AC powered chime
box. Remove chime box cover and connect the red and white wires to the existing terminal screws
(common and front) if connecting to the front door. Otherwise connect the red and white wires to the
(common and rear) screws for the rear door.
Next, plug the jack at the opposite end of the wire into the input on the side of the doorbell transmitter. To
test press the existing doorbell button in your home, if the red LED lights up the installation was
successful. If the red light does not light up check the wiring again, check if chime box has power, also
was the existing chime working before you installed the wire? Please note not all doorbell chime boxes
will work with the transmitter.
Mounting the Doorbell Transmitter
Use the provided hardware kit to mount the transmitter. See diagram above for doorbell transmitter set
up.
3
