Idiomas disponibles
Idiomas disponibles
The kickback is the result of an inappropri-
ate tool use or an incorrect operation. Can be
avoided following these instructions:
1. Keep a firm grip with both hands on the tool.
Position your body properly to resist the force of
kickback. The operator can control torque reac-
tions if the correct warnings are taken.
2. Never place your hand close to the rotating
accessory. It can cause a kickback over your
hand.
3. Never place your body on the kickback area;
the kickback will propel the tool to the opposite
direction of the rotation abrasive disc.
4. Use extra care when working with edges.
These tend to engage the disc.
5. Don't use the tool with cutting saws. These
produce kickback.
FEATURES
KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
5
1. SWITCH.
2. BACK HANDLE.
3. SIDE HANDLE.
4. WHEEL PROTECTOR.
5. SPINDLE LOCK BUTTON.
TECHNICAL DATA
EA505
VOLTAGE-FREQUENCY
NO LOAD SPEED
WHEEL CAPACITY
SPINDLE
POWER
WEIGHT
ASSEMBLY INSTRUCTIONS
WARNING: remove the grinder from the car-
ton and examine it carefully. Do not discard the
carton or any packaging material until all parts
are examined.
2
1
3
4
120 V ~ 60 Hz
11 500 r/min
5" (127 mm)
5/8"
710 W
1,75 kg (3,85 lb)
E N G L I S H •
LATERAL HANDLE
The lateral handle must
be used always that
the machine is run-
ning. Screw the lateral
handle inside the holes,
could be on the right,
left or supe-
rior side. Your choice is determined by your
convenience and ability to keep the complete
control.
GUARD
The guard is a security
device to prevent in-
juries caused by pieces
of abrasive disc. When
installing
the
guard,
make sure the raised rib
aligns with the slot on
the cover of the gearbox. Then turn to the left
the protector until stays in the correct position.
Before the operation, make sure that the guard
is locked on place. Release the fixed screws, the
guard can be adjusted to the desired position.
Once done this, adjust the fixation screw.
INSTALL AND REMOVE THE ABRASIVE DISC
To Install:
1. Make sure that the
guard is in its place.
2. Place the internal
adapter on the shaft.
Make sure that it is
placed
on
the
two
plane surfaces.
3. Check the abrasive
disc speed. Don't use
a
disc
which
speed
range is less than the
indicated on the label machine.
4. Press the spindle lock button, to prevent
movement.
5. Press and hold the
spindle lock button; ad-
just the exterior adapter
screwing on the clock-
wise direction with the
spanner.
To remove:
1. Press the shaft lock button.
2. Loosen the shaft lock nut by turning the nut
counterclockwise with the wrench.
3. Remove the outer flange screw.
4. Release the abrasive disc of the shaft.
U s er 's M an u al
11
