Idiomas disponibles
Idiomas disponibles
Restore Factory Settings
To reset all the factory settings, remove all power supplies from the device, then reconnect the power supply and press
the
and
,
,
steady on.
Access to Programming Mode
When turned on for the first time, or when restarting because factory settings were reset, the BTEL-3G asks which
language is to be used, as described below:
Press the key for the language to use and to confirm your choice, press the
keypad, an Installer Code must be entered via the BTEL-3G keypad as follows:
where <Installer Code> is a 5-digit number (the factory Installer Code is 11111). If the code entered is correct, the
Installer Menu will open.
IMPORTANT - Keeping the
you become aware that you are typing the wrong PIN, you need to wait a few seconds for the operation to be
canceled automatically, or type the
Access to programming mode is indicated by the RED LED
Parameters Management
In this section you can program the main settings for the BTEL-3G.
Phone Book Management
The dialler is provided from the factory without any programmed telephone numbers.
Write Phone Book
To program a phone number, type the following keypad sequence:
where <Position no.> is a number from
(the telephone number saved in the phone book under position no. 1 is 3470).
The dialler can memorize up to 9 telephone numbers: each number can consist of 16 digits at most.
Read Phone Book
To read the programmed phone number, type the following keypad sequence:
where <Position no.> is a number from
If, for example, you want the third programmed telephone number displayed (position no. 3 ) type
Delete
To delete the programmed telephone number, type the following keypad sequence:
where <Position no.> is a number from
If, for example, you want to delete the third programmed telephone number (position no. 3), type
12
keys simultaneously whyle the LED
= Italian,
<Installer Code>
key pressed for 3 seconds does not cancel the insertion of the Installer PIN; if
key to finish your entry and then try again.
<Position no.> <Telephone number>
to
while <Telephone number> is a number of up to 16 digits. For example:
to
.
to
.
is blinking. Release the keys when the LED
= English,
= French,
key. In order to program parameters by
(see the section "Status LEDs").
<Position no.>
<Position no.>
= Spanish
BTEL-3G
is
