Premier SOL-5533 Manual De Instrucciones página 16

battery positive(red connector) to the red cable (part No. 23). Connect the negative(black connector)
to the black cable (part No. 20). Never mis-connection. Connect tighten reliably.
7. Assemble the cover of the battery part back to the host.
Note: Keep this host indoor use only.
Step 2:
1. Take out the solar panels, put the solar panel outside and make it face to the sun: connect the
cable with the machine indoor, the battery is charged once the solar panel is connected the machine
when there is sunshine. (If this is the first time you use this machine, please charge for 3 continuous
days and then discharge the load, if the sunshine is not good, please charge the battery by the 12V
external battery charge from the city power.)
Remarks: The bracket should be bought by yourself.
If you would like the solar panel install on the roof, please ask a qualified installer to install this solar
system.
2. Connect the connector by the supplied cable.
3. Connect the solar panel cable to the solar panel input connector on the host. All the connection
cables have negative and positive part, never confuse them. Red to positive, black to negative.
Step 3:
1.Switch the breaker on. You can use the DC output power. Any DC 12V less than 24W loading is
acceptable.
2.Switch the small switch of the AC (part No. 2), You will get 120V AC 60Hz 500W or 800W pure sine
wave power from the USA sockets.
Remarks:
The two sockets share the rating output power of 500W or 800W. Please make sure the AC loading
is less than the rating output power, if the loads are motor or some complex loading, the load power