Installing The Base - With A Seat Belt - Hauck Varioguard Instrucciones De Manejo

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 61
GB

INSTALLING THE BASE - with a seat belt

Please Note: that your car seat is designed to fit only with a 3
point lap and diagonal seat belt and must not at any time be fitted
using only a 2 point lap belt (1).
IMPORTANT! Only use the red adult seat belt guides (G) and no
other load bearing points. Check if the adult seat belt buckle is
forward of the seat belt guides (G) on the car seat, or is in a
position that interferes with the seat belt fixing points, as it may not
be possible to get a secure installation of the car seat. If this is the
case, please try another seating position in the vehicle. If in doubt
please contact our customer service department.
WARNING! ALWAYS GIVE PREFERENCE TO USING THE
REAR SEATS OF YOUR VEHICLE EVEN IF YOUR HIGHWAY
CODE PERMITS THE USE ON THE FRONT SEAT. CHECK
YOUR HIGHWAY CODE AS THIS REGULATION MAY VARY
ACCORDING TO THE COUNTRY. CHECK THE VEHICLE
MANUAL FOR ADVICE ON FITTING YOUR CAR SEAT IN THE
FRONT OF THE VEHICLE. AIRBAGS CAN CAUSE INJURY. DO
NOT USE THIS CHILD SEAT ON A PASSENGER SEAT FITTED
WITH A FRONTAL AIRBAG.
Ensure the ISOFIX points are fully retracted. To do this, squeeze
together the ISOFIX adjustment buttons (R) located on either side
of the support leg at the front of the car seat base, and pull the
support leg towards you.
Fold out the support leg fully and place the car seat base onto the
vehicle seat (3).
Open the central red belt lock (H) (4). Extract the vehicle seat belt
and pass across the base.
Pass the lap section under both belt guides (G) making sure it
also passes through the belt lock (6) and pull the belt tight. Then
insert the vehicle seat belt connector (V) into the vehicle buckle
(W) (5).
Next pass the diagonal section under both belt guides (G) making
sure it also passes through the belt lock (6).
Ensure that the seat belt is pulled tight and is not twisted. Then
close the belt lock to secure the seat belt in place (7).
IMPORTANT! Always use the support leg when the car seat base
is fitted into the vehicle.
29
Tabla de contenido
loading

Tabla de contenido