Idiomas disponibles
Idiomas disponibles
Direction of rotation
• To bore and screw release the switch and and press the direction button on
the side where arrows point towards the chuck.
• To reverse the turn, and unscrew press it on the other side.
• The drill switch will get blocked if the button sits in the middle.
CAUTION
• The first time you turn on the drill and after reversing
rotation you might hear a click. This in normal and does not represent a
problem.
CAUTION
• To prevent damaging the tool, never reverse the rotation
direction while the drill is running.
Speed selection
• The two speeds in the drill work in a similar manner to those used in cars.
• Low speed (1) will give a lot of torque (torsion power). Use this speed when
starting to drill large orifices, be it wood or metal. This will prevent the bit to
get stuck.
• High speed (2) has a reduced torque but lets the drill operate with higher
revolutions per minute, that make the tool when in the drill function to bore
faster lean metal or wood.
Change from hammer drill / drill / drivers
• To bore concrete, tiled floor or materials similarly hard, turn the function
selection collar into the IMPACT (
the same time onto the material.
• To bore metal or plastic turn the function selection collar into the DRILL (
position to make the bit rotate against the material.
• For screw / unscrew turn the function selection collar to this position
(
) so the bit turns over the screw for better control.
WARNING
Do not try to drill metal, wood or plastic with the hammer
drill in the IMPACT mode. Otherwise the tool efficiency would diminish and the
bit tip will get damaged.
Torque Adjust
• To select the desired torque level to screw drive, turn
the torque regulator until it matches the corresponding
number with the upper mark:
From 1 to 4 for small screws,
From 5 to 9 for screws on soft materials,
From 10 to 15 for screws on soft and hard material.
On 16 to 21, for larger screws.
CAUTION
• The torque level necessary depends
on the type of screw to be used and the material onto
which you are working. If in doubt use a lower torque
and increase gradually until reaching the right one. An
adequate torque prevents damaging the tool.
8
ENGLISH
) position. The bit will strike and rotate at
Preparation
Forward
)
Function
selection collar
Torque
regulator
Reverse
