Step 1: Charging
Fully charged
charging
Step 2: With Remote controller
Indicator
H Mode
M Mode
L Mode
Turn Off
to turn on the insoles
Step 3: Without Remote controller
Heat Setting
= High Temperature Mode
Red
Red & Green
= Medium Temperature Mode
= Low Temperature Mode
Green
If the insoles do not respond to the remote controller: (note: this is also applicable if you receive a
new remote controller)
Press the power button on each insole for 3 times quickly until the LED indicator of each insole
1)
starts blinking.
Press any button on the remote, the indicator will stop blinking, pairing finished.
2)
Step 4: Sizing your heated insoles
There are size cutting lines on the underside of your heated
insoles, carefully cut along the line corresponding to your feet
size , or use your existing insoles as a template. (Note: do not
cut below the dotted lines as this may damage the insoles)
Charge both insoles with the dual
charger by inserting the usb cable into
the charging port found on the insoles.
The light on the charger will turn green
when fully charged.
Temperature adjustment to
turn on the insoles by remote
Three Modes
control, then set the desired
Temperature Control
heat setting by pressing the
corresponding button on the
(H/M/L)
remote as below.
Press any one of
(please note that you cannot
H/M/L button
turn on the insoles with the
remote controller due to
safety regulations)
Select the desired heat setting by
pressing the power button on the
insoles, press repeatedly to cycle
through the heat setting (High /
Medium / Low)
2
English
Deutsch
Français
Nederlands
Dansk
Svenska
Norsk
Suomi
Polski
Español
Italiano
Czech
Slovak
Hungarian
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
