TREVIDEA Girmi RC55 Manual Del Usuario página 12

- Power off the device while changing attachment.
- Clean and lubricate the clipper regularly to ensure
better performance and longer life.
- Never leave unattended while it is running.
- Do not wrap the power cord around the unit during use.
- If the adaptor breaks or gets lost, contact an authorized
service center for replacement.
Pay attention to the features of the adaptor, if you
decide to change it. An incorrect voltage may damage
the motor and jeopardize the functionality of the
device.
1. Blade
5. Charging light
9. Small brush
OPERATING
The hair clipper can be recharged using the adaptor and it can be used both weather it is connected to the
adaptor or not.
WARNING: if during battery working the appliance stop working, put switch (4) in OFF position, connect
adaptor (11) to power supply and pin (12) to connector (6). Wait one minute before starting again operation.
HOW TO USE
- Keeping off the unit, mount one of the supplied combs (7). Choose the attachment depending on the length
you wish to obtained (see figure below).
- If you want to obtain a shorter cut, between 0.8mm and 2mm, use the clipper without any comb (7), but
with the supplied comb. If so, set the cutting height using the regulator (3).
- Turn on the clipper and start cutting.
- Once finished cutting operation, turn off the device using the power button (4), remove any comb and store
the clipper and its accessories out of the reach of children.
RECHARGING
CAUTION: to recharge the clipper, only use the adaptor supplied.
If the adaptor gets lost or damaged, contact an authorized service center and do not use any other adaptor
which may damage the internal battery and jeopardize the functionality of the device. When you first use the
product fully charge it, leaving it connected to the charger for at least 2 hours.
Plug the power adaptor (11) to the power outlet and the connection pin (12) into the socket on the rear of
product (6). During charging operation, the LED (5) is red. When battery is fully charged, it becomes blue.
The following measures will preserve the battery life.
Before first use, charge the battery by leaving the hair clipper connected to the adapter for about 2 hours.
DESCRIPTION RC55
3. Cutting regulator
6. Charging input
10. Lubricating oil
4. On/off button
7. 4 combs set
11. Adaptor 12. Connection pin
11